Knowledge

The nature and role of solid silk



Solid wires are free of charge, halogen leads, and melting points and filaments in water. The main harmful odor, colophonium restricted tin wire, mainly in the lead, the lead in the body now has a physical region, is implemented and performed with the halogen, recently will also be greatly reduced by the human body injury, but also because of the price, the cost, it requires a lot of difficulties. Solid to remove tin oxide. At the same time, inch surfactants begin to work on the feet, solid wires, which can greatly reduce the amount of liquid in the material. Reflecting liquid, liquid and on the foot and strengthen communication can pass into the hard assignment start time welding volume surface tension or melting points in the alloy at any time is in use and head to determine the temperature due to various material size on the performance and efficiency of the above and the temperature of 100 degrees.

Solid wires with feet for constant flow, with rosin and a small amount of welding active material of the solder wire are using standard solid wire welding very wires, brazing "name" or rosin core solder. For the use of tools and raw white manufacturers through the iron in the head of the heater head, the shell diameter is very small thickness, which is different behavior can not play iron, iron, and sometimes cause shortcomings.

Solid iron wire welding line constant head temperature process is very important: the temperature control of iron, the most suitable choice of the iron head, the first temperature measurement temperature very early work head tip temperature) is tin wire on the surface of a fluid leaves permanently welding tin, because of unnecessary. As a result of the influence of the pin on the pin flow, even in order to prevent negative phenomena, such as top and welding. The wires are free for multiple points, halogen wires, and melting wires in water. The main harmful odor, rosin rosin (restricted) tin wire, mainly in the lead, the lead in the body now has a physical region, is implemented and performed with halogen, solid wire recently will also be greatly reduced by the human body injury (in the country), but also because of the price, the cost of it requires a lot of difficulties. Line rich permanent exhibition, in the exhibition, especially 100 degrees, it is probably also the cigarette is very exhibition aluminum foil packaging, people will aluminum foil, sweets, to prevent moisture (in recent years in China, from the aluminum foil film - foil aluminum foil instead of gradually, aluminum foil is very easy to compare). However, the plasticity of the tin is distinguished between the lighters, which has a very poor tearing, solid wire, which is woven from the gas retention usually installed in a factory. This significantly reduces the margin, where the operator (preferred) (mask) or other protective device, it is unlikely to damage themselves.

Solid wire making to replace tin aluminum toothpaste case in recent years) it also contains tin, lead, tin and general interest, with 50% tin, some of which are in the 90% or even 6 to 4% weight of lead and tin, silver wire is permanent in paragraph 7.3, soft metal, low melting point only, coal block, which increases the melting furnace of mercury, solid wire which is a liquid. Tin, gently cut. At room temperature, it is stable, oxidizing, and can not always be silver, so tin is often non-toxic, covering the inner walls of copper and copper pots with warm water to avoid the formation of toxic toothpaste shells (usually they can also be used for toothpaste, lead, tin, two layers and layers in the middle of manufacture).